Advertisement
3.
Secure the left light assembly and right light
assembly to the light cross mount using the lock
washer and hex nut on the light assemblies
(Figure
20).
Note:
Install the lights with the low beam toward
the outer edge of the machine.
Look at the bottom of the lights for high beam
and low beam orientation.
Figure 20
1. Light assembly
2. Lock washer
4.
Apply the yellow reflective tape to the light cross
mount using the dimensions shown in
Figure 21
1. 9.5 to 10.1 cm (3-3/4 to 4 inches)
g303701
3. Hex nut
Figure
g303699
5
Installing the Rear
Components
Parts needed for this procedure:
1
Left mount
1
Right mount
1
Left short mount
1
Right short mount
4
Carriage bolt (5/16 x 3/4 inch)
4
Flange nut (5/16 inch)
4
Carriage bolt (1/4 x 5/8 inch)
11
Locknut (1/4 inch)
4
Hex-head bolt (3/8 x 3 inches)
4
Locknut (3/8 inch)
4
Red reflective tape
1
Marker mount
2
Back mount
1
Slow-moving vehicle sign
3
Flat washer
7
Flange-head bolt (1/4 x 3/4 inch)
1
Left light housing
21.
1
Right light housing
9
Advertisement
