Table of Contents
Advertisement
0 Shunt
Current test – Min.
resistance shunt
75Ω Resistor
EPC and field wiring -
Supervisory resistor
(jumper)
Magnetic Hanger
Case
NOTE: The Output Analyzer comes with a charging cord but does not come with a wall charger or a 1-Ohm Resistor
used in EPC testing.
Please obtain a charger to fully charge the battery before testing. To ensure this device remains compliant with EMC
Directive 2014/30/EU, the unit shall not be used while charging the battery and the battery charger used for charging
the device shall be compliant with the requirements of EN61326-1.
The 1-Ohm Resistor is included in the E10-070 kit purchased by EP Service Technicians, of which the 10-2983 Output
Analyzer is a part.
PAGE / 2
10Ω Resistor
Current test – Max.
resistance resistor
P/N 10-2989
(jumper)
2-Position Plug
Current test – Field wiring
plug
P/N 10-2991
USB Charging Cable
P/N 02-16502
P/N 02-16506
USB A to USB C, 5Vdc
ONLY!
P/N 10-2990
P/N 02-16516
USB A
P/N 02-16505
DO NOT
charge at higher voltages!
Electrical damage will occur!
Doc. P/N 06-905
Rev. 1 / December 2018
USB C
Advertisement
Table of Contents
