Features; Approvals; Safety Information - Fike 10-2983 Product Manual

2.0 FEATURES

 On-off switch
 Back-lit LCD display
 Rechargeable battery
 Removable test jumpers
 Durable plastic housing
 Can be used to test fire the EPC
 Replaces cumbersome and outdated flashbulbs for testing
 Substitutes portable oscilloscopes for electrical measurements
 Finds series/parallel wiring faults in an EPC system by examining supervisory current levels anywhere in the field
wiring loop

3.0 APPROVALS

The Analyzer has been tested and complies with the limits for a Class A digital device, pursuant to Part
15 of FCC rules. When the equipment is operated in a commercial environment, these limits provide
reasonable protection against harmful interference. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference with radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case the user will be required to correct the
interference at his or her own expense. Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this equipment.
This product complies with the essential requirements of the following applicable European directive(s)
and carries the CE marking accordingly: (1) EMC Directive 2014/30/EU; and (2) RoHS Directive
2011/65/EU.

4.0 SAFETY INFORMATION

WARNING - When wired to the EPC, the Output Analyzer is capable of activating the EPC when the
ACTIVATE button is pressed, even when the device is turned off. Prior to using the tool, verify that all
GCA's connected to the EPC series firing circuit (P3-2) are disconnected from the circuit. For ARM (10-
1832) testing, disarm the GCA as noted in the 06-106 ARM Manual. For IRM (10-2748) testing, remove
the IVO from the container and IRM.
CAUTION – Do not use the Output Analyzer if it appears to be damaged or if the device doesn't appear
to be working according to the supplied user instructions.
CAUTION – Do not use the Output Analyzer on any solenoid circuit or damage will occur!
STATIC DISCHARGE – Use a grounding strap to eliminate static discharge sources prior to working with
GCAs.
IMPORTANT: Pack and safely store the Fike Output Analyzer when not in use. Do not allow the Analyzer to remain
connected to live circuitry, as this will reduce battery life.
Doc. P/N 06-905
Rev. 1 / December 2018
PAGE / 3