Select Synchronization Method - KoamTac KDC300 User Manual

Select Synchronization Method

There are two synchronization options that user can select.
Fast Synchronization in burst mode
User can synchronize KDC300 with PC in burst mode or handshaking mode. Burst mode provides faster
synchronization process if selected destination of data is a file.
Clear KDC300 memory after synchronization
User can clear KDC300 memory after synchronization if this option is selected. KDC300 can store
maximum 10,240 or 200K byte barcode data.
It is important to clear KDC300 memory periodically to prevent memory full status which will prevent
user from storing additional data.
Data can be deleted using KDC300 menu options if this option is not selected.
Automatically synchronize after connection
User can synchronize collected data with PC automatically by selecting this option.
It is important to configure other synchronization options properly before performing an automatic
synchronization operation.
Data synchronization can be done manually by clicking synchronize icon if this option is not selected.
Beep while synchronization
User can enable or disable beep tone during the synchronization process. KTSync program generates a
beep tone for each barcode data coming from KDC300 if beep tone is enabled. It beeps 5 times once
KTSync finishes synchronization process.
KDC300 User Manual
32