Yamaha Tyros3 Service Manual page 29

5
Remove the four screws to remove the installed
hard disk unit from the bracket.
6
Attach the new hard disk unit to the bracket
using the four screws removed in step 5.
Make sure the bottom of the hard disk is facing up.
Depending on the type of hard disk drive you plan to
install, select holes or holes
drive.
* Holes are used in this illustration.
7
Set the Tyros3 right-side up.
8
Insert the hard disk bracket into the slot.
NOTE
If you have installed the hard disk that was once used for the Tyros/Tyros2 and turn the Tyros3's power on, you can
immediately view the fi les on the hard disk and use the Song fi les from the Tyros/Tyros2. However, to properly use the Style,
Multi Pad, and Registration Memory fi les from the Tyros/Tyros2, you will need to convert the data using a computer and the
File Converter software (available for free download on the Tyros3 website).
You should tighten these two
screws first.
to attach the hard disk
9
Turn the Tyros3 face down again and fasten the
three screws removed in step 3.
10
Check that the installed hard disk is functioning
properly.
Set the Tyros3 right-side up, and turn the power on. If the
HD tab appears on the File Selection display, the hard
disk is OK.
Tyros3
29