Table of Contents
Advertisement
5.
Replace the main drawer. (Refer to 5.4 "Replacing the main
drawer" under Section 5 "REMOVINGTHE TOP CABINET AND MAIN
DRAWER".)
At this time draw out the remote drawer cable through cable hole
o
A
shown in Fig. 16. Use care to prevent the cable from being
caught by anything.
6. The following describes the method for securing the remote drawer
on a table by use of the supplied balancing metal fixtures.
(1) Choose a flat table.
(2) Lay down the drawer so that the left side faces downward.
(3) With the cushion areas of the fixtures directed to the
drawer bottom, insert them in two holes at the left side
(looking from the front) so that the drawer bottom plate can
be inserted in the U-shaped grooves of the fixtures. These
fixtures must be fitted in the same direction and level.
(See Fig. 19)
Insert deepinto
thegroove.
Fig. 19
Fig. 20
Adhesive face
(4) Peel off the protective seal from the cushion area. The
adhesive area is then exposed. Don't lay a table cloth on
–51–
- Quick Links:
- Programming
Hide quick links:
Advertisement
Table of Contents
