Sharp ER-3100 Installation Manual page 26

Data A, B, and C do not need to be changed. Enter the
same data as data A, B, and C of job number 909 shown in
the SRV-mode program list printed
installing the option.
2. PGM-mode programming
(1) Programmingto select data handling
The ER-31Rs2 has the following four
which can be enabled or disabled by
programming.
0 Sending of print data
0 Sending of report print data
0 Loading of RAM data
0 Dumping of RAM data
a. Programmingprocedure
Perform this programming in the PGM
followingprocedure.
When A, B, C, and
D are all zeroes
by job number 900 before
functions
data handling functions,
the PGM-mode
mode by using the
'~AB~D
$ ,~ zgo~~~~
A, B, C, and D are all set to zeroes
when master resetting is taken.
Table 5
A Sending of print data Enable/Disable
1/0
B Sending of report print data Enable/Disable
1/0
c Loading of RAM data Enable/Disable
1/0
D Dumping of RAM data Enable/Disable
1/0
–22–