Replacing The Light Bulbs - Toro 68062 Installation Instructions Manual

5

Replacing the Light Bulbs

No Parts Required
Replacing the Rear-facing Bulbs
Note: The left rear-facing bulb also illuminates license plate.
1. Use a screwdriver to remove the 4 screws from the
large square lens on the light (Figure 17).
A B
D E
Figure 17
2. Remove the lens (Figure 17).
3. Push and twist the bulb counterclockwise to remove it
from the socket (Figure 17).
4. Push a new 1157 bulb into the socket and then twist it
clockwise (Figure 17).
5. Install the lens and the 4 screws (Figure 17).
Replacing the Side-facing Bulbs
1. Use a screwdriver to remove the 2 screws from
the small rectangular lens on the side of the light
(Figure 18).
C
F
G020829
8
A B
D E
Figure 18
2. Remove the lens (Figure 18).
3. Pull the bulb out of the socket (Figure 18).
4. Push a new 168 bulb into the socket (Figure 18).
5. Install the lens and the 2 screws (Figure 18).
C
F
G020830