Adjusting The Pivot Stop Bolts - Toro Sand Pro 2040Z Operator's Manual

Connecting the Frame Bracket
1. Remove the nut and the bolt securing the muffler
shield to the back of the machine (Figure 16).
Figure 16
2. Align the bolt holes in the frame bracket with the bolt
holes in the frame.
Note: Ensure that the chains are crossed as shown
in Figure 17.
Figure 17
Machine not shown
3. Secure the frame bracket with 4 bolts (5/16 x 1 inch)
and 4 flange nuts (5/16 inch); refer to Figure 16).

Adjusting the Pivot Stop Bolts

1. Pivot the rake to 1 side. The stop bolt should contact
the drawbar when the rake is 51 mm (2 inches) away
from the tire (Figure 18).
If there is 51 mm (2 inches) of clearance between the
rake and the tire, no adjustment is necessary.
1. 51 mm (2 inches)
G023806
2. Determine whether there is not enough clearance or
too much clearance between the tire and the rake.
•
If there is not enough clearance, loosen the flange
locknut.
•
If there is too much clearance, loosen the jam nut.
Note: Use a wrench on the square neck of the bolt to
prevent the bolt from spinning.
1
1. Stop bolt
G023816
2. Flange locknut
3. When the stop bolt is in position so that there is 51
mm (2 inches) of clearance between the rake and the
tire, tighten the appropriate nut.
•
If you loosened the flange locknut, tighten the jam
nut now.
•
If you loosened the jam nut, tighten the flange
locknut now.
10
1
Figure 18
2 3 4
Figure 19
3. Jam nut
4. Square neck
G023918
G023923