Attaching The Boom; Attaching The Cables - Toro Sand Pro 2040Z Operator's Manual

3. Insert the bolt (3/4 x 3-1/2 inches) to secure the
drawbar to the pivot assembly.
4. Install the locknut (3/4 inch) onto the bolt, and torque
it to 163 to 217 N-m (120 to 160 ft-lb).
5

Attaching the Boom

Parts needed for this procedure:
1 Boom assembly
2 Carriage bolt (3/8 x 3/4 inch)
2 Flange nut (3/8 inch)
1 Bolt (1/4 x 5/8 inch)
Procedure
1. Align the holes in the plate at the bottom end of the
boom assembly with the holes in the plate near the rear
of the drawbar (Figure 8).
1
5
1. Flange nut—3/8 inch (2)
2. Bolt (1/4 x 5/8 inch)
3. Boom
2. Install 2 carriage bolts (3/8 x 3/4 inch) into the holes,
and secure the bolts with 2 flange nuts (3/8 inch).
3. Install the bolt (1/4 x 5/8 inch) in the hole in the front
of the plates.
2
4
Figure 8
4. Carriage bolt—3/8 x 3/4
inch (2)
5. Drawbar
6

Attaching the Cables

Parts needed for this procedure:
2 Cable
4 Shoulder bolt
4 Flange nut (5/16 inch)
Procedure
1. Align the end of each cable with a hole in the end of
the rake (Figure 9).
Note: To decrease the chance of binding, ensure
that the ends of the cables are positioned as shown in
Figure 9.
1
3
G024506
1. Shoulder bolt
2. Cable
2. Secure each cable with a shoulder bolt and a flange nut
(5/16 inch).
3. Route the other end of each cable through the
appropriate cable support, and align each with a hole in
the top of the boom assembly (Figure 10).
Note: To decrease the chance of binding, ensure
that the ends of the cables are positioned as shown in
Figure 10.
6
2
3
Figure 9
3. Flange nut (5/16 inch)
G024507