Setup - Toro Sand Pro 2040Z Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
Media and Additional Parts
Description
Bolt (5/16 x 2-1/2 inches)
Flange locknut (5/16 inch)
Shackle
Bolt (3/4 x 4-1/2 inches)
Locknut (3/4 inch)
Short spacer
Bolt (5/16 x 1 inch)
Flange locknut (5/16 inch)
Description
No parts required
No parts required
Center assembly
Right-side assembly
Left-side assembly
Bolt (3/4 x 3-1/2 inches)
Locknut (3/4 inch)
Long spacer
Cable guard
Drawbar
Bolt (3/4 x 3-1/2 inches)
Locknut (3/4 inch)
Long spacer
Boom assembly
Carriage bolt (3/8 x 3/4 inch)
Flange nut (3/8 inch)
Bolt (1/4 x 5/8 inch)
Cable
Shoulder bolt
Flange nut (5/16 inch)
Stop-chain assembly
U-bolt
Flange nut (5/16 inch)
Qty.
–
–
1
1
1
2
2
2
2
1
1
1
1
1
2
2
1
2
4
4
1
1
2
Qty.
2
2
2
1
Install the rake to the machine.
1
2
4
4
3
Use
Adjust the tire pressure.
Remove the shipping board from the
machine.
Connect the center assembly and the
side assemblies.
Connect the drawbar to the rake.
Attach the boom.
Attach the cables.
Attach the stop-chain assembly.
Use