Installing The Hood Assembly And Bags - Toro E-Z Vac Z Master Z400 Series Operator's Manual

4
Installing the Hood Assembly
and Bags
Parts needed for this procedure:
1 Hood assembly
2 Bags
2
Clevis pin
2 Hairpin cotter
Procedure
1. Install the hood assembly into the bagger-mounting
bracket (Figure 13).
Figure 13
1. Bagger-mounting bracket
2. Install the 2 clevis pins into the hood assembly and
bagger-mounting bracket. Secure it with 2 hairpin
cotters (Figure 14).
2. Hood assembly
1. Hood assembly
2. Bagger-mounting bracket
3. Install the bag tab into the notch in the hood assembly
(Figure 15).
Note: Do this for all bags. The bags rest on the
bagger frame.
1. Hood assembly
2. Bag
3. Bag tab
4. Lower the bagger hood over the bags
9
Figure 14
3. Hairpin cotter
4. Clevis pin
Figure 15
4. Notch
5. Bagger frame
(Figure 16).