Table of Contents
Advertisement
2
Adjusting the Transport
Frame Hitch
Parts needed for this procedure:
2
Hitch Pin
2
Hairpin Cotter
Procedure
1.
Measure the height from the ground to the top
of the hitch on the tow vehicle.
2.
Adjust the transport frame hitch up or down
according to the measurement of the machine
hitch. Use the appropriate mounting holes as
shown in the table below and in
Tow Vehicle Hitch
Height
Below 11 inches
11 to 15 inches
Above 15 inches
1. Hitch
2. Bottom mounting holes
3.
Secure the frame hitch to the machine hitch with
the hitch pin and hairpin.
4.
Raise the jack, remove the ball pin from the jack,
and rotate the jack so that it is in the storage
Figure
4.
Frame Mounting Holes
Bottom (2) sets of holes
Middle (2) sets of holes
Top (2) sets of holes
Figure 4
3. Middle mounting holes
4. Top mounting holes
position. Install the ball pin to secure it in the
storage position
3
Installing the Control Tower
Parts needed for this procedure:
1
Lower tower
1
Upper tower
2
Capscrew (3/8 x 2-3/4 inch)
2
U-bolt
6
Flange nut (3/8 inch)
Procedure
1.
Loosely secure the lower control tower to the
center frame tube with 2 U-bolts and 4 flange
nuts (3/8 inch) as shown in
1. Lower control tower
2. Center frame tube
3. U-bolts and flange nuts
g012753
2.
Mount the upper control tower to the lower
control tower with 2 capscrews (3/8 x 2-3/4 inch)
and 2 flange nuts (3/8 inch) as shown in
5.
Note:
Using the holes in the upper control tower
tube, adjust the height of the tower to the lowest
possible position while still being comfortable for
the operator.
8
(Figure
16).
Figure
5.
Figure 5
4. Upper control tower
5. Capscrews and flange
nuts
g012754
Figure
Advertisement
Table of Contents
