Black & Decker M300 Manual page 5

Electrical safety
This tool is double insulated in accordance with
EN 60335; therefore no earth wire is required.
Always check that the power supply corresponds
to the voltage on the rating plate.
To avoid the risk of electric shock, do not immerse
the cord, plug or motor unit in water or other liquid.
Features
1. Speed control switch
2. Eject button
3. Turbo switch
4. Motor housing
5. Mixer release button
6. Stand
7. Bowl
8. Platform
Fig. A
9. Beaters
10. Dough hooks
Fig. D
11. Platform release
Unpacking
Remove all packaging from the appliance.
Clean the appliance before first use.
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Fitting and removing an attachment (fig. A)
Use the beaters (9) for blending, beating, mixing, whisking
and creaming.
Use the dough hooks (10) for kneading.
Assembling the beaters/dough hooks (fig. A)
Fit the required attachments (9 or 10) through the holes
in the platform (8) or motor housing (4) and push until
they are fully located.
Note: The attachment (b) must be fitted into the larger hole
on the motor housing (4) or the platform (8) (M650 only).
Remove the attachments (9 or 10) by pressing the eject
button (2).
Note: The speed control switch (1) must be at the 0 "Off"
position before the attachments can be ejected.
Note: The platform (8) should be in the raised position
before the attachments are ejected.
Stand assembly (fig. C) (M650 only)
With the attachments removed, place the mixer on the
platform (8) such that the 3 holes align with the catches
(12) and the pin (13). Press down to lock the mixer in
place.
Press the platform release (11) on the back of the
platform and lift the mixer to the raised position.
Fit the required attachments (9 or 10) through the holes
in the platform and push until they are fully located.
Lower the mixer to the operating position, making sure
that it locks in place.
Use
M300 (figs. A and B)
Fit the attachments (9 or 10) to the appliance by
inserting them into the 2 holes and pushing until they are
fully located in the motor housing (4) (fig. A).
Connect the appliance to a suitable electrical supply.
Place the beaters/dough hooks in the ingredients and
move the speed control switch (1) to the required speed.
When mixing is complete, return the speed control
switch (1) to the 0 ("Off") position.
When the speed control switch is in the 0 position and
all parts have stopped moving, the attachments can be
removed by pressing down on the eject button (2).
M650 (figs. A, B, C and D)
Press the platform release (11) on the back of the
platform (8) and lift the mixer to the raised position
(fig. D).
Fit the required attachments (9 or 10) to the appliance
through the holes in the platform (8) and push until they
are fully located.
Note: The attachment (b) must be fitted into the larger hole
on the platform (8).
Add the ingredients to the bowl (7), place the bowl on
the stand (6), and lower the mixer to the operating
position, making sure that it locks in place.
Move the speed control switch (1) to the required speed.
When mixing is complete, return the speed control
switch to the 0 ("Off") position.
Press the platform release (11) on the back of the
platform (8) and lift the mixer to the raised position.
The beaters can be removed by pressing down on the
eject button (2).
ENGLISH
5