Installer Settings Menu (Hidden Screen) - Trane Z WAVE TZEMT400AB32MAA User Manual

Thermostat User Guide

Installer Settings Menu (Hidden Screen)

The Installer Settings screen is a hidden screen designed for installer use only. Do not change any settings in this screen
unless you are a qualified service technician. Changing these settings will affect the operation of the heating/cooling
system.
To enter this screen, go to the main menu selection screen and press and hold the two inner buttons for 3
seconds until the Installer Settings screen appears.
The Installer Settings screen displays the current internal settings of the thermostat. You can view and change the
settings from this screen. Scroll to the desired function and use the +/- buttons to change.
Display Lock:
Y = Display LOCKED
N = Display unlocked
Allows you to lock or unlock the thermostat buttons. When the buttons are locked, you can still access the main menu, but
you will not be allowed to select any menu options. The Installer Settings hidden button operation is always operational,
allowing you to return to this screen and turn Display Lock off.
System Settings Menu
Mechanical Settings Submenu
Type
Selects HVAC type, Gas/Electric or Heatpump
Fan Type
Selects the Fan type if system is Gas or Electric
C/O Type
Set the Heat pump Changeover type
2nd Stage Heat
Enables the 2nd Stage Heat operation
Aux Heat (HP)
Enables the Auxiliary Heat operation. Typically the Aux Heat will be heat-strips in a Heatpump system
2nd Stage Cool
Enables the 2nd Stage Cool operation
Schedule Enable
When enabled, the local thermostats scheduler function is enabled.
Note on Delta Settings: The Delta T Setting is the delta, or difference between, the setpoint and current temp for
determining when a heat or cool call comes on. The "delta" is the number of degrees away from setpoint.
H/C Delta
Sets the minimum separation between heating and cooling setpoints. Attempts to lower the cooling below the
heating setpoint by this amount will PUSH the heating setpoint down to maintain this separation. Same for setting
the heating setpoint above the cooling setpoint, it will PUSH the cooling setpoint up to maintain this separation.
Heating Delta Stage 1 ON
Sets the delta from setpoint that stage 1 heating starts.
Heating Delta Stage 1 OFF
Sets the delta from setpoint that stage 1 heating stops. Stage 1 turns off at setpoint + Delta Stage 1.
27
Range: Y or N
Range: Gas/Elec or Heatpump
Range: Gas or Elec
Range: w/Cool or w/Heat
Range: Y or N
Range: Y or N
Range: Y or N
Range: Y or N
Range: 3 - 15 degrees.
Range: 1 to 8 degrees
Range: 0 to 8 degrees
Default: N
Default: Gas/Elec
Default: Gas
Default: w/Cool
Default: N
Default: Y
Default: N
Default: N
Default: 3
Default: 1
Default: 0