2) GENERAL OUTLINE • Secure the joint by tightening the appropriate screws supplied, as in fig. The SILENTE system is compatible with the EElink protocol for fast 9. The door opener is thus ready to be installed. installation and maintenance.
Page 3
SILENTE SILENTE • Fix the two supporting brackets to the ceiling, as in fig.12. Recheck AMPO) Sets the amperometric limit switch trigger current during the everything and fix the two supporting brackets to the gearmotor base opening manoeuvre. When the limit switch is triggered, it stops the door plate.
SILENTE SILENTE • Memory cancellation • Check the manual opening control operation. • Parameter reading • Check the opening and closing operations using the control Leave the J1 jumper open. The UNIPRO connection only allows reading of devices fitted. those values set using the trimmers. Connect the UNIPRO programmer to •...
Page 5
SILENTE SILENTE PROGRAMMING FIG. 2A FIG. 1A LEGEND Close jumper MITTO 2-4 in the control unit Green Blinking Emits 1 blink TRC 4 TRC 1-2 MITTO 2-4 TRC 4 TRC 1-2 Menu A Menu A - TRANSMITTER STORAGE Blinking Simultaneously press...
Page 6
SILENTE SILENTE PROGRAMMING Menu B Menu C Menu C - QTELEC CONTROL UNIT MEMORY CANCELLATION Simultaneously press To cancel another T key from the transmitter itself or another transmitter control unit keys SW1 and SW2 once and release Press P1 on the...
Page 7
SILENTE SILENTE Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 7 Fig. 6 Fig. 8 AUTOMATION FOR SPRING OVERHEAD DOORS AUTOMATION FOR SPRING OVERHEAD DOORS...
Page 8
SILENTE SILENTE Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig. 14 AUTOMATION FOR SPRING OVERHEAD DOORS AUTOMATION FOR SPRING OVERHEAD DOORS...
Need help?
Do you have a question about the SILENTE and is the answer not in the manual?
Questions and answers