Table of Contents
Advertisement
If...
Step 6.
If as part of system set up and configuration, you did not enable disk ownership automatic
assignment, manually assign disk ownership; otherwise, go to the next step:
a.
Display all unowned disks:
storage disk show -container-type unassigned
b.
Assign each disk:
storage disk assign -disk disk_name -owner owner_name \
You can use the wildcard character to assign more than one disk at once.
Step 7.
Verify that in-band ACP was automatically enabled.
storage shelf acp show
In the output, "in-band" is listed as "active" for each node.
8
Installation and Cabling Guide for DM120S, DM240S, and DM600S
Then...
cabling is correct, a root aggregate is present,
and run system-level diagnostics to identify
any faulty components.
h. Complete system setup and configuration as
instructed by the "Installation and Setup
Instructions" that came with your system.
Hide quick links:
Advertisement
Table of Contents
