Connecting (Simatic Mv320); Connecting And Removing Cables - Siemens SIMATIC MV320 Operating Instructions Manual

Connecting (SIMATIC MV320)

NOTICE
Avoid exceeding the maximum voltage
If the maximum voltage is exceeded, this voids the manufacturer's guarantee.
● Maximum voltage tolerance: 5 V ± 10 %
● The components must comply with the requirements of the EC directive RoHS and the
REACH Regulation: See EC directive 2011/65/EU (RoHS 2) and the Regulation (EC) No.
1907/2006 (REACH Regulation).
4.1

Connecting and removing cables

Connecting the cable
● Plug the RJ-50 end of the cable into the bottom of the device handle.
Press the connector firmly into the device until it audibly locks in place. The cable is then
correctly connected.
SIMATIC MV320 / SIMATIC MV325
Operating Instructions, 08/2015, C79000-G8976-C352-03
4
21