Preparation Of The Tv Set; Installation Of The Tv Set; Preparation Of The Remote Control - Gazer TV22-HS2 User Manual

Installation of the TV Set:

EN
Carry out the operations as follows to use the TV set comfortably and safely:
Carefully take the device out of the box, remove all transport means of
•
protection (foam holders, protective wrapping);
In addition, remove the entire protective film from the device;
•
If you are going to fasten the TV set on the wall with a bracket, use the VESA
•
mounting holes on the back cover of the device;
When choosing the installation location, pay attention to the stability of the
•
surface. An unstable, rocking piece of furniture may be a cause of the TV-set
tipping over;
While fastening the TV set on the wall fixture, be attentive and reliably fasten
•
the TV set in order to avoid any injuries from the device fall;
After installing the TV set, plug in the power-supply cable into the socket. Lay
•
the power-supply cable so as to avoid any tension or break that may lead to
the cable damage�
6

Preparation of the TV Set

To ensure the operation of the control, it is necessary to insert batteries therein.
The remote control is powered by two AAA 1�5 V batteries�
The following operations should be carried out to install the batteries inside the
remote:
Carefully open the cover of the battery section;
•
Install two batteries in the correct polarity (pursuant to the diagram inside the
•
section);
• Carefully close the cover of the battery section�
In case of the normal use, new batteries are to operate about half a
Note:
year. If you are not going to use the TV set for a long period of time, remove
the batteries out of the remote�

Preparation of the Remote Control