Turning On The System; Menu Bar; Display Icons; User Or Admin Login - Eyemax DVST HSD804 User Manual

4 channel h.264 stand-alone dvr

Hide thumbs Also See for DVST HSD804:

Table of Contents

1-2. Turning on the System

Connecting the power cord will turn on the power of DVR. It will take approximately 10 to 20

seconds for the system to be initialized. Once the system is initialized, it will display quad

screen, and begin to record video automatically.

To turn off the system, select SHUTDOWN under main menu (MENU > SHUTDOWN)

Note:

and unplug the power cord when the shutdown message appears

The menu bar will appear on the bottom of the screen as shown below.

: Pressing the Menu will bring up the main menu list

"%" : Shows the % of HDD being used

: Turns on when the HDD is set to be overwritten.

: Turns on when the system is connected to the network

: Turns on when the Alarm is being activated

: Recording

: No Recording

: Event Recording

: Pre Event Recording

: Motion Detection

: Sensor Detection

: Sequence

: PTZ Camera

Press MENU to enter main menu screen. Login in screen appears to enter ID (Admin or

User) and Password. Password can be set up to 8 numbers by the combination of numbers

from 1 to 4. The factory default password is 'none' so press OK to log in to the system.

Password can be set under password set up option (MENU > SYSTEM > Password). System

will be automatically log out if it is not in-use for sometime. This "Auto Logout Time" can be

set under password set up option (MENU > SYSTEM > Password).

Table of Contents