Table of Contents
Advertisement
Chapter 2. Using DVR
1. Basic Operation
1-1. Front Panel & Remote Controller
USB Port : USB ports on the front panel provides following functions:
i. Back Up files using USB Flash Memory or USB-IDE HDD
ii. Control the system using USB Mouse
iii. Save/Load the system settings using USB Flash Memory.
HDD LED : LED will be on when data is being recorded or searched in HDD.
NETWORK LED : LED will be on when the system is being connected via network.
ALARM LED : LED will be on when the alarm is being activated.
: Press the 'Menu' button to enter/exit the setup screen.
: Press the 'Playback' button to enter playback mode.
: Display Camera no.1 / Focus on far distance under PTZ mode.
: Display Camera no.2 / Focus on near distance under PTZ mode.
: Display Camera no.3 / Zoom In under PTZ mode.
: Display Camera no.4 / Zoom Out under PTZ mode.
: Move forward by one frame under Pause. Use this button to move up when setting
the menu.
: Move backward by one frame under Pause. Use this button to move down when
setting the menu.
: Plays the video backward. Press the button repeatedly to increase play speed up to
max 32 times (1, 2, 4, 8, 16, 32 times) faster. Use this button to move left when
setting the menu.
: Plays the video forward. Press the button repeatedly to increase play speed up to
max 32 times (1, 2, 4, 8, 16, 32 times) faster. Use this button to move right when
setting the menu.
If press the 'Playback' button during playback, it will
pop up the playback menu.
: Press the 'Backup/Move' button to enter back up
menu. But the button can be also used to display menu
to load PTZ presets under PTZ mode.
: Press the 'Display/Preset' button to change display
mode from Quad to Sequence or Sequence to Quad. But
the button can be also used to display menu to save PTZ
preset under PTZ mode.
: Press the button to complete the settings. Under playback mode, the
button can be used to pause the playback screen.
10
Advertisement
Table of Contents
