Lifting With A Crane; Storage - Dantherm DanX AF Series User Manual

2. TRANSPORTATION

2.3 Lifting with a crane

Never stand under a module when it is lifted with a crane as there always is a risk that the
crane or helping material can be damage! Serious injuries or death can be the result!
When lifting the modules with a crane, be aware of the following general points:
•
Only use a hoist that can manage the weight of the module!
•
Never use a hoist which is damaged!
•
Use soft straps!
•
Lift the module cautiously, without jerky movements!
•
Do not touch down hard!
Lifting is done the following way:
•
Insert 2 bars of round iron (min. 1 ½") in the holes of the base frame and secure them.
•
Use four soft straps, push them over the iron bars and put them together in the crane
hook.

2.4 Storage

If the unit is not installed at once but should be stored, note the permissible storage
conditions:
•
Do not leave the unit standing outside, but in a building.
•
Do not remove the original packaging.
•
Protect the unit until the installation from dust, dirt and damage.
•
The air temperature in storage should be between 5 °C to 40 °C.
•
The storage should be in a non-condensing atmosphere.
If the unit is delivered with a separate control panel, it should be handled with special caution
and stored in a safe and dry location until the installation is carried out.
5