Remote Control - James Loudspeaker M102 Owner's Manual

Remote Control

POWER MUTE
1
SOURCE
BT
3
ANALOG
VOLUME
4
COAX
5
OPTICAL
6
HDMI ARC
7
EQ
9
VOICE MOVIE MUSIC
Figure 4: Remote Control
How to change batteries in the remote control:
• To change batteries, use a Phillips head screwdriver (not provided) to remove the screw at the
bottom base of the remote. Remove the cover and the (2) AAA batteries.
• Make sure the polarity of the new batteries is correct when inserting it into the battery
compartment. Then secure the cover and the screw.
1
Power
Use the power key to turn the device on/off.
2
(If the amplifier is turned off with the remote
control, auto-sense on will be deactivated.)
2
Mute Button
The mute button allows the device to be muted and unmuted.
The LED will flash while the amplifier is muted.
BT Button (Bluetooth)
3
8
Selects the Bluetooth input and the LED will turn blue.
Also used for pairing. Refer to section 'Bluetooth: Pairing' on
page 10 for details on pairing a device.
4
Analog Button
Selects the analog inputs and the LED will turn green.
Coax Button
5
Selects the digital coaxial input and the LED will turn white
6 Optical Button
Selects the digital optical input and the LED will turn yellow
HDMI ARC Button
7
Selects the HDMI-ARC digital input and the LED will turn purple
8 Volume Buttons
The volume can be adjusted with the volume up button
^ and volume down button v. The LED will flash while the
volume is changing and will stay solid when the min/max
volume is reached.
Voice, Music and Movie Buttons
9
Pressing the Voice, music or movie buttons activates special
DSP algorithms, resulting in a greater sense of depth and width.
®
The LED will flash for 3 seconds to indicate acceptance.
9