Operation And Functions - James Loudspeaker M102 Owner's Manual

Operation and Functions

Bluetooth: Pairing
Press the Bluetooth (BT) button, the blue LED light will blink on the front of the amplifier.
• There is no connection if blue LED is flashing slowly.
• The Bluetooth is in pairing mode if blue LED is flashing rapidly.
• The Bluetooth is paired if the blue LED lights continuously.
Pairing mode can be activated by pressing the BT button for three seconds on the remote control. The
speaker emits a confirmation tone, disconnects the current Bluetooth connection and is visible to other
devices. The pairing beacon will be "JLSM102". The pairing must be executed within one minute,
otherwise the unit will default back to the last connected device.
Adjusting the Bluetooth Volume
Virtually all devices that output an audio signal via Bluetooth have their own volume control. For the
best audio quality, it is recommended to the set the volume of the source device to maximum and
adjust the playback volume with the remote control.
Auto Power Off (Auto Signal Sense)
The system has an automatic power off function that cannot be deactivated. When one of the inputs
Bluetooth or Analog is selected, the system switches to standby mode after a maximum of 20 minutes
without audio input.
With the digital inputs COAXIAL, OPTICAL TOSLINK, and HDMI-ARC, the auto-off circuit reacts directly
to the absence of a digital data stream and thus allows a faster switch-off. The playback device must
deactivate the data stream accordingly.
Auto Power On and Automatic Source Selection
The electronics of the system has an automatic power on function that automatically wakes it up from
standby mode as soon as a sound signal or digital data stream is present. The function is only active
if the system has been put into standby mode by the automatic switch-off function. The signal must be
present at the input that was selected during the automatic switch-off process. (This function is not
available for Bluetooth devices.) If standby mode is set manually by pressing the on/off button on the
remote control, the automatic switch-on function is deactivated.
HDMI-ARC and CEC
To enable sound transmission from the TV to the system both the CEC (Consumer Electronic Control)
and the ARC (Audio Return Channel) functionality must be activated on the TV set. This is the default
condition and the TV should automatically detect the external speaker. (Refer to the TV owner's manual
for instructions if necessary.) If these functions are active, both the TV and the remote control can
control the volume of the system.
10