Table of Contents
Advertisement
Connections
Caution - All connections to the SoundBar amplifier must be made before you
connect to the main power.
ACCESSING THE AMPLIFIER CONNECTIONS
The amplifier connections can be accessed by removing the 4 screws on the front panel and tilting the
amplifier down on its hinge. The arrows below show the 4 screws to remove with your Phillips head
screwdriver (not included).
8
6
5
HDMI ARC
OPTICAL
MODEL NO.: M102
7
HDMI ARC
OPTICAL
MODEL NO.: M102
6
Figure 1: Removing the 4 screws to access the connections.
4
3
SUB OUT
AUX IN
L
R
COAX
S/N:
Figure 2: Back of Amplifier with connections
SUB OUT
AUX IN
L
R
COAX
S/N:
Figure 3: Top View of SoundBar with Amplifier Secured in Place
IR Sensor
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
FCC ID: 2AUGD-M102
including interference that may cause undesired operation.
CAUTION
RISK OF ELECTRIC SHOCK
CAUTION:
DO NOT OPEN
ATTENTION
WARNING:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
FCC ID: 2AUGD-M102
including interference that may cause undesired operation.
CAUTION
RISK OF ELECTRIC SHOCK
CAUTION:
DO NOT OPEN
ATTENTION
WARNING:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
1
ON
TO REDUCE THE RISK OF FIRE REPLACE WITH
ONLY THE SAME TYPE AND RATING FUSE.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOSTURE.
ON
TO REDUCE THE RISK OF FIRE REPLACE WITH
ONLY THE SAME TYPE AND RATING FUSE.
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOSTURE.
AC 100-240V
50/60Hz 160W
STANDBY < 0.5W
2
AC 100-240V
50/60Hz 160W
STANDBY < 0.5W
Advertisement
Table of Contents
