Other Jacks On The Media Center Panel; Connecting An Optional Antenna Extender; Connecting The Optional Ir Emitter Cable; Data Port For System Backups - Bose LIFESTYLE 18 II Series Quick Setup Manual

Other jacks
on
the media center panel
Connecting an optional antenna extender
If your remote control does not communicate with the media center, the batteries may need
replacement or it may be out of transmission range. To extend the range, plug an antenna
extender, which may be purchased at an authorized Bose® dealer, into its connection on the
media center. See Figure 27 on page 30.
Connecting the optional IR emitter cable
The IR (infrared) emitter cable is designed for optional use when a particular component does
not respond to L1FESTYLE® system remote control commands. That is, the component is
connected to the media center, but placed where it cannot receive the IR signals from the
media center. The IR emitter can be placed next to one component only. See Figure 27 on
page 30.
To use the emitter:
1. Insert the 3.5 mm plug into the IR EMITIER jack on the media center panel.
2. Place the flat side of the other end of the cable near the unresponsive component so that
the remote control signals reach that component.
)
Note: Refer to "Controlling external sources" in your
LJFESTYL~
system Operating Guide for
details on how to program the
LJFESTYL~
system remote so that it works with your other
component.
3. Confirm that IR signals now work to control that component. Move the emitter around, as
necessary, to find the best position.
4. Use the double-sided tape enclosed with the emitter to affix it in the proper position.
)
Note: If you have questions, or need to obtain a replacement emitter, contact Bose customer
service. Refer to the Bose address list included with your system.
Data port for system backups
Some systems will have a data port for future use. See Figure 27.
Serial data jack
This jack is for factory and service use only.
31