Page 1
DTC GT-211 DOG TRAINER Signal Dog selection Indicator: 0 for both dogs 1 or 2 for dogs 1 or 2 Battery Level Beep, vibrate and shock Dog Selector (0,1 or 2) level indicator and levels adjustment Control (The M Button)
Page 2
Quick Start for Training Screw the prongs onto the receiver-collar, plug the charger supplied into the DC port of the receiver-collar and charge for up to 3 hours for the first few times. When the charger is plugged into the DC port the receiver-collar will B-Beep and Vibrate once to indicate that charging has started.
Page 3
By pressing up or down the M button you can increase or reduce the beep, vibrate and shock levels. A quick press of the B-beep, Vibrate or Shock buttons will create a short B-Beep, Vibrate or Shock at the collar selected. Pressing on for a longer time will create a longer B-beep, Vibrate or Shock.
Page 4
Safety To maximise the effectiveness of the MGG GT-211 remote training system and safety of your dog, check the fit of the collar frequently and readjust the position of the electrodes on the animal’s neck whilst checking for signs of irritation or discomfort.
Page 5
Make sure the receiver-collar is NOT turned off by checking the signal icon on the transmitter. If the receiver-collar is turned off, the transmitter will not be able to send out a signal to it and the signal icon light will not flash accordingly. Make sure the dog you need to train is correctly selected.
Page 6
This product is designed for use with dogs only. 4. Limitation of Liability In no event shall MGG be liable for any direct, indirect, punitive, incidental, special or consequential damages or any damages whatsoever arising out of or connected with the use or misuse of this product.
Page 8
For parts and service please email: info@mgg.co.nz...
Need help?
Do you have a question about the DTC GT-211 and is the answer not in the manual?
Questions and answers