Subscribe to Our Youtube Channel
Related Manuals for MGG Trainertec DTC1200V
Summary of Contents for MGG Trainertec DTC1200V
- Page 1 Trainertec DTC1200V Remote Controlled Dog Training Collar Operator’s Manual www.mggproducts.co.nz...
- Page 2 Thank you for choosing MGG Trainertec. We want to ensure your dog’s safety by providing you with the tools and techniques to successfully train your dog. If you have any questions please contact us by email info@mggproducts.co.nz visit our website at www.mggproducts.co.nz...
- Page 3 15. Full functional multi-dog training system 16. Around 8 seconds safe static shock protection 17. 2-year warranty PLEASE CHARGE UP COLLARS AND REMOTE BEFORE USE. THE COLLARS AND REMOTE HAVE BEEN MATCHED ALREADY FOR YOU BY MGG PRIOR TO DELIVERY. Transmitter Antenna LCD display...
- Page 4 “ ” button: Emit a static shock stimulation. Press 1 time to give one short shock . Press and hold on to give a continuous shock. It will automatically cut out after the 8 seconds maximum. “1,2,3 ” buttons: Dog Selection Button , default is “1” . Your transmitter is capable of training up to three dogs with optional extra receiver collars.
- Page 5 Step 3 : Press and hold the “ ” button and the “ ” button at the same time until the digital number on the LCD display changes automatically then release. The transmitter enters the “match receiver” mode . The number changes like “08,09,10,11……”, increasing automatically . Step 4 : Hold the transmitter close (50~100mm) to the unmatched receiver.
- Page 6 Press dog selection button to choose correct Dog ID before press transmitter buzz control button. The Beeper component is loose. Please send to the MGG service center to repair . Problem#3: The stimulation seems too high, not high enough or no feeling at all The collar strap is not tight enough.
- Page 7 Check the transmitter to see if the battery is low. Charge transmitter first . Cancel the receiver match and then re-match it with transmitter . If receiver does not work either then please send it back to the MGG service center to repair or replace . - 7 -...
- Page 8 MGG Products, 29C Mill Lane, Kerikeri 0230, New Zealand www.mggproducts.co.nz info@mggproducts.co.nz Ph. 09 401 6360 - 8 -...
Need help?
Do you have a question about the Trainertec DTC1200V and is the answer not in the manual?
Questions and answers