Electrical Connection - Miele PUR 98 D Operating And Installation Instructions

Electrical connection


Installation, repairs and other
work by unqualified persons could
be dangerous. The manufacturer
cannot be held liable for
unauthorised work.
All electrical work must be
undertaken by a suitably qualified
and competent person in strict
accordance with current national and
local safety and building code
regulations.
The rangehood must be connected to a
mains electricity supply which conforms
with current local and national
regulations.
For extra safety, it is advisable to install
a residual current device (RCD) with a
trip current of 30 mA.
Connection of this appliance should be
made via a suitable isolator which
complies with national and local safety
regulations and the On-Off switch
should be easily accessible after the
appliance has been built in. Means for
disconnection must be incorporated in
the fixed wiring in accordance with the
wiring rules. When switched off, there
must be an all-pole contact gap of
3 mm in the switch (including switch,
fuses and relays according to EN
60335).
The connection data is given on the
data plate (See "After sales service").
Ensure that this data matches the
household mains supply.
42
If a flexible connection cable is being
used to connect the appliance to the
electricity supply, the cross-sectional
area of the the individual leads must be
between 0.75 mm² and 1.5 mm².
The strain relief must be used to ensure
problem-free connection.