Dell Dimension XPS Manual page 19

Documentation
4. Connect the new drive to the set of rails that are attached to the inside of the cover. If a set of rails is not attached
inside the computer cover, contact Dell.
5. If you are installing a replacement drive and the new drive does not have the bracket rails attached, remove the rails
from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive by
aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four
screws (two screws on each rail). See the diagram.
6. Gently slide the drive into place until the tabs securely click into position.
7. Connect the power and CD/DVD drive cables to the drive.
If you are adding a drive that has an audio cable, connect the audio cable to the audio connector on the audio card.
8. If you are installing a new CD/DVD drive rather than replacing a drive, remove the front-panel inserts.
http://support.dell.com/support/edocs/systems/dimxpsg2/en/SM/parts.htm (19 of 37) [3/26/2008 3:57:09 PM]