Dell Dimension XPS Manual page 16

Documentation
1. Follow the instructions in
2.
Open the computer cover.
3. If you are replacing a drive and the new drive does not have the bracket rails attached, remove the rails from the old
drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the
screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two
screws on each rail). See the diagram.
4. Gently slide the drive into place until the tabs securely click into position.
5. Attach the power and floppy-drive cables to the floppy drive.
6. If you are installing a new floppy drive rather than replacing a drive, remove the front- panel inserts.
From inside the drive bay, gently press on each side of the insert until it pops out.
7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
http://support.dell.com/support/edocs/systems/dimxpsg2/en/SM/parts.htm (16 of 37) [3/26/2008 3:57:09 PM]
"Before You
Begin."