Advertisement
Frequently Asked Questions (FAQ)
Q1. The Power LED is not lit.
The Power LED should be lit when the power system is
working normally. If the Power LED is not lit, check as
follows:
Make sure the power adapter is connected to the
A1:
switch with power source properly.
Make sure the voltage of the power supply meets the
A2:
requirements of the input voltage of the switch.
A3:
Make sure the power source is ON.
Specifications
General Specifications
Standard
IEEE802.3, IEEE802.3i, IEEE802.3u, IEEE802.3ab, IEEE802.3x
CSMA/CD
Protocol
Ethernet: 10Mbps (Half Duplex), 20Mbps (Full Duplex)
Data Transfer Rate
Fast Ethernet: 100Mbps (Half Duplex), 200Mbps (Full Duplex)
Gigabit Ethernet: 2000Mbps (Full Duplex)
10Base-T: UTP category 3, 4, 5 cable (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
100Base-TX: UTP category 5, 5e cable (maximum 100m)
Network Media (Cable)
EIA/TIA-568 100Ω STP (maximum 100m)
1000Base-T: UTP category 5e cable (maximum 100m)
EIA/TIA-568 100Ω STP (maximum 100m)
Interface
5/8 10/100/1000Mbps Auto-Negotiation RJ45 Ports
Power, Link/Act LED
LED Indicators
Store-and-Forward
Transfer Method
Automatically learning, automatically aging
MAC Address Learning
10Base-T: 14881pps/Port
Frame Forward Rate
100Base-TX: 148810pps/Port
1000Base-T: 1488095pps/Port
Wall Mountable
Yes
Distance Between
LS1005G: 38mm
Mounting Holes
LS1008G: 48mm
Environmental and Physical Specifications
Operating Temperature
0˚C to 40˚C (32˚F to 104˚F)
Operating Humidity
10% to 90%RH non-condensing
5% to 90%RH non-condensing
Storage Humidity
To ask questions, find answers, and communicate with
TP-Link users or engineers, please visit
https://community.tp-link.com to join TP-Link Community.
For technical support and other information,
please visit https://www.tp-link.com/support, or simply
scan the QR code.
If you have any suggestions or needs on the product guides,
welcome to email techwriter@tp-link.com.cn.
Q2. The Link/Act LED is not lit when a device
is connected to the corresponding port.
It is recommended that you check the following items:
A1:
Make sure that the cable connectors are firmly plugged
into the switch and the device.
A2:
Make sure the connected device is turned on and
works normally.
A3:
The cable must be less than 100 meters long (328 feet).
Safety Information
Keep the device away from water, fire, humidity or hot environments.
Do not attempt to disassemble, repair, or modify the device. If you need service,
please contact us.
Do not use damaged charger or USB cable to charge the device.
Do not use any other chargers than those recommended.
Adapter shall be installed near the equipment and shall be easily accessible.
Place the device with its bottom surface downward.
TP-Link hereby declares that the device is in compliance with the essential requirements
and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC,
2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at https://www.tp-link.com/en/ce.
Advertisement
