Saeco DA 7P Plus Instructions For Installation And Use Manual page 12

1 0
8
6
• To check beverage dispensing quality insert coins, press the button corresponding to the desired beverage, and wait until beverage
has been dispensed. Should coffee be dispensed too slowly, adjust the grinder to a coarser setting ; should coffee be dispensed too
quickly, adjust the grinder to a finer setting (lower numbers=finer grind / higher numbers = coarser grind).
Attention : following the grinder adjustment, brew at least two coffees to evaluate the change.
• Make sure the instant product bin latches are open, remove the safety key (33) and close the door.
• Wait until the green LED "Ready for use" comes on.
All machine data, including beverage counts, system data, etc. can be obtained with use of the handheld 7P Programmer.
The 7P Programmer is an accessory and must be purchased separately.
8.6 Assembly of the PARALLEL NRI G 13 coiner
24
• Turn the machine on (main switch on back of the machine to position "1"), then run a
rinse cycle through the water system, following the procedure below :
• Open the door and insert key (33) into slot (32) enabling safety sensors (Fig. 14).
WARNING: Altough the front door of the machine is open, the key (33)
enables the machine to remain in operating mode. Refer to authorized service
personnel or use extreme caution when carrying out all procedures with the opened door.
Priming :
• Keep button (27) pressed until a regular jet of water streams out of one of the dispensing
Fig. 14
tubes (7).
Grinder adjustment :
• The grinder can be adjusted to one of the following suggested values by turning the
grinder adjusting ring (23) (Fig. 15):
Italy: 4-7 Spain: 5-8 France - Switzerland: 5-8
Germany - Austria: 6-9 USA - Canada: 6-14
Fig. 15
Only a parallel type coiner can be used with this equipment.
- Remove the front adhesive panel on the door covering the coiner recess.
- Fasten the coiner to the door with the 4 screws and nuts supplied (Fig. 16).
- Connect the flat cable to the coiner (Fig. 17).
• To prevent the coiner from accepting a type of programmed coin, push up the cor-
responding dip-switch (46) (Fig. 17).
Fig. 16
Once the coiner has been assembled, program the channel coin values and prices
according to the following instructions :
• Press button (26), which activates the programming mode. The machine will not
dispense beverages. To perform programming operations, use the first four buttons on
the front panel. Data menu changes can be read from the display. Symbols showing
the button functions have been placed beside the corresponding button.
Fig. 17
English