Toro 133-0554 Installation Instructions Manual page 6

1. Opening in the LED work
light
4
Installing the Rocker Switch
Parts needed for this procedure:
1 Rocker switch
1 Work-light decal
Procedure
1. Remove the plastic plug from the left side of the dash
(Figure 7).
Figure 6
2. Wire-harness connector
1. Plastic plug
2. Insert the rocker switch into the opening and apply the
work-light decal to the left of the rocker switch
8).
1. Work-light decal
3. Connect the female connector attached to the wire
harness to the rocker-switch blades
1. Rocker-switch blades
6
Figure 7
Figure 8
2. Rocker switch
(Figure 9).
Figure 9
2. Female connector
(Figure