Display Functions - Miele G7106 Operating Instructions Manual

Guide to the appliance

Display functions

The display is used to select or set the
following:
- the program
- the Timer
- the Settings 
The display can show the following:
- the program stage
- The estimated time left for the pro-
gram to run
- Any relevant fault messages and in-
formation
To save energy, the dishwasher
switches off after a few minutes if you
do not press any buttons during this
time.
Press the  button to switch the dish-
washer back on.
18
The OK button is used to confirm a
message or setting and also to move to
the next menu or another level.
Under  More, a scroll bar  will ap-
pear in the right of the display. This of-
fers further options. These options can
be shown using the  buttons.
You can alter the dishwasher's controls
to suit changing requirements in the
"Settings" menu (see "Settings").
The option which is selected will have a
check  next to it.
To exit a sub-menu again, press the
Back button.
If you do not press any buttons for sev-
eral seconds, the display will revert to
the previous menu. You will then have
to enter your settings again.
These operating instructions apply to
several different dishwasher models of
different heights.
The specific dishwasher models are
referred to as follows:
Standard = 31 11/16" (80.5 cm) high
dishwashers (integrated)
and 33 1/4" (84.5 cm) high dishwash-
ers (freestanding)
XXL = 33 1/4" (84.5 cm) high dish-
washers (integrated).