Miele G7106 Operating Instructions Manual page 74

Frequently Asked Questions
Problem
White residue is visible
on the dishes. Clouding
has occurred on glass-
ware and cutlery. The
film can be wiped off.
There are rust stains on
the cutlery.
74
Possible cause and solution
The rinse aid dosage is set too low.
 Increase the dosage (see "Rinse aid" under "Set-
tings").
The salt reservoir is empty.
 Fill the salt reservoir (see "Reactivation salt" under
"Before using for the first time").
The salt reservoir cap has not been screwed on cor-
rectly.
 Replace it, making sure that it screws back on cor-
rectly.
Unsuitable combination detergents were used.
 Switch to another detergent. If using tabs or pow-
der detergent, do not choose combination prod-
ucts and ensure you refill the reactivation salt and
rinse aid.
The water softener is programmed to too low a water
hardness level.
 Program the water softener to a higher water hard-
ness level (see "Water hardness" under "Set-
tings").
The affected items are not corrosion resistant.
 No remedy.
Purchase cutlery which is dishwasher-proof.
A program was not run after reactivation salt was
added. Traces of salt have got into the normal wash
cycle.
 Always run the  QuickIntenseWash program
with the  Express program option selected and
without any dishes in the dishwasher after adding
reactivation salt.
The salt reservoir cap has not been screwed on cor-
rectly.
 Replace it, making sure that it screws back on cor-
rectly.