Steam Ironing - Champion CHSJ310 User Manual

ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate. The resin filter is per-
manent and does not need replacing. Please note: Use tap water only. Distilled and/demineralized water makes the "Zero-Calc"
anti-calc system ineffective by altering its physicochemical characteristics. Do not use chemical additives, scented substances or
decalcifiers. Failure to comply with the above-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics. Always iron these fabrics at low temperatures.
The plate may cool down to the point where no more steam comes out, but rather drops of boiling water that can leave marks or
stains. In these cases, the Anti-drip system automatically activates to prevent vaporization, so that you can iron the most delicate
fabrics without risk of spoiling or staining them.
AUTOMATIC SHUT OFF
The automatic shut off device trips after the iron has been left for approx. 8 minutes in the upright position or unused for approx.
30 seconds in the horizontal position. The light comes on to indicate that shut off has tripped. As soon as you move the iron, the
device turns off and the iron starts working again.
GENERAL INSTRUCTIONS
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding
plastics. This is quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth before
using it for the first time.
PREPARATIONS
Tvätten skall strykas i enlighet med de internationella symbolerna på plaggets etikett, eller om detta saknas , i
enlighet med typen av tyg.
LABEL
.
..
...
Start ironing the garments requiring a low temperature. This reduces the waiting times (the iron takes less time to heat up than to
cool down) and eliminates the risk of scorching the fabrict.

STEAM IRONING

Filling the reservoir
1. Check that the plug is disconnected from the socket.
2. Move the steam selector (3) to "0" [Fig. 1].
3. Open the lid (2).
4. Raise the tip of the iron to help the water enter the opening without overflowing.
5. Slowly pour the water into the reservoir using the special measure (14) and taking care not to go over the maximum level
indicated by "MAX" on the reservoir [Fig. 2].
6. Close the lid (2).
Selecting the temperature
1. Put the iron in a vertical position.
2. Put the plug in the socket.
3. Adjust the thermostat knob (12) according to the international symbol on the garment label [Fig. 3]. The plate temperature
pilot light (13) indicates that the iron is heating up. Wait until the plate temperature pilot light goes off before ironing.
Warning: during ironing, the plate temperature pilot light (13) comes on at intervals, indicating that the selected temperature is
maintained. If you lower the thermostat temperature after ironing at a high temperature, do not start ironing until the plate
temperature control light comes on again.
Selecting the steam
1. The quantity of steam is regulated by the steam selector (3).
2. Move the steam selector to a position between minimum and maximum depending on the quantity of steam required and
the temperature selected [Fig. 1].
Warning: The iron gives off steam continuously only if you hold the iron horizontally. You can stop the continuous steam by placing
the iron in a vertical position or by moving the steam selector to "0". As indicated on the thermostat knob (12) and in the initial
table, you can only use steam at the highest temperatures. If the selected temperature is too low, water may drip onto the plate.
FABRIC TYPE
Synthetic
Silk - wool
Cotton - linen
THERMOSTAT
.
Low temperature
..
Medium temperature
...
High temperature
EN