Preparation Of Espresso Coffee - HAEGER Expresso Italia CM-85B.009A Instruction Manual

English
Before the First Use
• It is recommended to rinse the coffee maker before the first use. The coffee
maker should also be rinsed after a longer period without use. Refer to the
instruction in the "Cleaning and maintenance" chapter.
• Use the appliance as if it were about to make an espresso coffee but
without any coffee, to flush through all of the internal parts of the coffee
maker.
• There may be noise and no water come out when pump the water at the
first time, it is normal, you should turn the steam regulator to the opening
position to release the air in the appliance. After about 20s, the noise will
disappear, and the water will come out.
• You cannot brew espresso if you have not flushed the machine at first; the
flushing cycle causes the boiler to fill with water. If you have not used the
machine for a few days, you must flush it with fresh water before you use it
again.

Preparation of Espresso Coffee

To make a cup of good hot Espresso coffee, we recommend you preheat the
appliance before making coffee, including the filter holder, filter and cup, so
that the coffee flavour cannot be influenced by the cold parts.
1. Make sure that all buttons are in the "OFF" position and that the steam
control knob is closed by turning it clockwise.
2. Open the tank cover and pour water into it, the water level should not
exceed the "MAX" mark in the tank. Then close the water tank cover.
NOTE: The appliance is supplied with a detachable tank for easy cleaning,
you can fill the tank with water firstly, and then put the tank into the
appliance.
3. Plug in to a power source and turn the device on by pressing the ON/OFF
switch. The coffee maker will start to pre-heat and the blue LED will blink.
4. Choose the right filter (for two cups or for pod) and put it into the filter
holder.
5. When coffee maker is ready, the LED will stop blinking and shine
continuously.
6. Hold the filter holder below the boiler outlet and turn it to clockwise. Make
sure the handle of the filter holder aligns with groove in the appliance, then
move it to the right from the "INSERT" position to "LOCK" position.
7. Place a cup on removable shelf and press the button "coffee switch" and
wait for a few seconds, then press "coffee switch" again to close the flow of
the water. Pour out the hot water in the cup of preheating process.
8. Fit the suitable coffee filter into the filter holder. Use the pod cup filter or the
4 Instructions for use