Table of Contents
Advertisement
INSTALLATION
INSTALLATION PROCEDURES
3.2. INSTALLATION PROCEDURES
Please refer to the operator's manual for details.
3.2.1. Before Connecting the Power Cables
The PSU (Power Supply Unit) automatically recognizes the input voltage.
•
Input voltage: 100 to 120 / 220 to 240 V ac
•
Input frequency: 50 / 60 Hz
I
WARNING
Please note that using a supply voltage other than specified above
may damage the scanner or reduce its operating life.
3.3. PACKING
When transporting the scanner, do the following.
3.3.1. Power Cord
1) Make sure that the power switch is off.
2) Pull out the power cord from the wall outlet.
3) Pull out the power cord from the scanner.
4) Coil the power cord and place it into the inner box.
3.3.2. Packing
Move the carriage to its home position (this locks it into position).
Set the shipping pads on the right and left of the scanner, then place the
scanner in the shipping carton.
Please refer to the installation section in the operator's manual for details.
3-2
October 9th, 1995
Advertisement
Table of Contents
