2-2 Configuration with the MobileRACK
The following information is for reference only. The VPM-6248T is
factory configured with the MobileRACK docking case installed
with these settings.
Jumper JP6, and CN6 with a 2-wire red-black cable connector,
are located on the rear PCB panel of the enclosure. These enable
operation of the MobileRACK with the VPM-6248T enclosure.
The default jumper setting for JP6: pins 2-3 ON.
Power
Switch
JP6
CN6
2-pin
Red-Black Cable
3
JP6 (2-3 ON) & CN6 : configuration with
2
MobileRACK (factory default setting)
1
Factory Configuration with MobileRACK
VPM-6248T USER MANUAL
Power
USB
Conn.
Port
JP7
Temperature
Control
Jumper
JP8
Temperature
Control Jumper
LED
Fan
Power
40-Pin IDE Data
Connector
9