Getting Started; Set-Up - Consumer Cellular 101 User Manual

This product meets applicable national SAR limits of
1.6W/kg. The specific maximum SAR values can be
found in the RADiOWAVES section of this user guide.
When carrying the product or using it while worn
on your body, either use an approved accessory
such as a holster or otherwise maintain a distance of
www.sar-tick.com
10mm from the body to ensure compliance with RF
exposure requirements. Note that the product may
be transmitting even if you are not making a phone call.
PROTECT YOuR HEaRING
To prevent possible hearing damage, do not listen at
high volume levels for long periods. Exercise caution
when holding your device near your ear while the
loudspeaker is in use.
5
1

Getting started .....................

1.1

set-up

Removing or installing the back cover
Inserting or removing the sIm card
The SiM card and battery are normally pre-installed for you. Follow these
instructions should you ever need to access them yourself. Please power
off your phone and remove battery before inserting or removing the SiM
card.
Place the SiM card with the chip facing downwards and slide it into its
housing. Make sure that it is correctly inserted. To remove the card, press
and slide it out.
6