Removing The Coin-Cell Battery Holder; Pairing With A Bluetooth Device - Dell Active Pen User Manual

Removing the coin-cell battery holder

About this task
Table 2. Removing the coin-cell battery holder with tools.
Using a coin or a flat-head precision screwdriver, unscrew the
coin-cell battery holder from the top cover.
Table 3. Removing the coin-cell batteries
NOTE: Perform the following procedure if there were
coin-cell batteries installed in the product.
Remove the coin-cell batteries from the coin-cell battery holder.

Pairing with a Bluetooth device

About this task
NOTE: You can use Dell Active Pen only with selected Dell computers and tablets. For the list of supported devices, see
www.dell.com.
NOTE: If the pen is already listed under Bluetooth devices, remove the pen from the list before pairing with your device.
Steps
1. Press and hold the top button for 3.5 seconds to enable pairing mode.
The Bluetooth-pairing light starts blinking to confirm the pairing mode is enabled.
Figure 5. Turning on Bluetooth
2. In Windows Search, type Bluetooth.
3. From the list that appears, tap or click Bluetooth Settings.
4. Ensure that the Bluetooth is enabled.
5. From the list of devices, tap or click Dell PN557W Pen→ Pair.
NOTE: If Dell PN557W Pen is not listed, ensure pairing mode is enabled on the pen.
8 Setting up your Dell Active Pen
Figure 3. Removing the coin-cell battery holder with a tool
Figure 4. Removing the coin-cell batteries