JUKI PS-700 Instruction Manual page 8

8)

❶
9)

Top end of the screw must not
protrude from this section.
C

10)


C




8) Temporarily fix bobbin winder tension controller
(asm.)  on bobbin winder device mounting plate
❶ with nut  .
9) Aligning shorter thread guide section C of bobbin
winder tension controller (asm.)  with the direc-
tion of bobbin  , tighten nut  .
Take care not to allow the top end
of screw of bobbin winder tension
controller (asm.)  to protrude from the
end face of nut  in order to prevent
hands and fingers from being injured.
10) Pass the thread through thread guide  , bob-
bin winder tension controller (asm.)  in the
written order. Then, wind thread on bobbin  .
If bobbin  is wound with thread
unevenly, loosen nut  and adjust the
direction of rotation of thread guide
section C.
– 5 –