Installing The Water Supply Mop Kit - Samsung VR20T6001M Series User Manual

Installing the water supply mop kit

• Please disconnect and power off the Mopping Robot when you install or detach the
water supply mop kits.
• Please wring the water out of the mops prior to use, otherwise the cleaning process
may slow down.
Caution
• Make sure to fill the water supply mop kit before use. Using the product without water
in the water supply mop kit may cause static electricity.
How to install the water supply mop kit
1 Wet mops thoroughly with
clean water, then wring
water out.
4 Fill the water supply mop kit
with clean water.
* Water only
Caution
We recommend you wash the
mops with detergent before
first time use.
8 English
2 Attach the mop pads to the
water supply mop kit. (See
the figure above.)
5 Close the rubber cap of the water supply mop kit and attach
to the bottom of the main unit. (Pressing down while gently
turning side to side. You will hear a click when they attach.)
Correct
Please make sure the rubber
cap is fully closed after filling
the water tank. Failure to close
may result in product failure or
malfunction.
3 Open the rubber cap of the
water supply mop kit.
Wrong Correct
When attaching the water supply
mop kit to the main unit, refer to
the figure above. The main unit
will not work properly if they are
not attached correctly.
Wrong