Scheppach 19013 04901 Translation From Original Manual page 23

Circular saw bench
Table of Contents

Advertisement

Available languages
  • EN

Available languages

Fig. "L"
2mm
3
5
Fig. "L1"
Fig. "M"
1
4
3
2
2
Sawblade - riving knife
Fig. "L"
1 holding rnandrel
2 left-handed hex. nut
• Take out the left hand table inlay.
• Insert the holding mandrel (1) into the saw spindle via the
bore in the right- hand side of the table. For releasing or
tightening the hex. nut M 20 (2) the saw spindle is locked
with the holding mandrel.
• Note the sawblade running direction.
Riving knife
• Release the screw (3), insert and clamp in the riving knife.
The distance between the sawblade and the riving knife (4)
must amount to no more than 8 mm and must be checked
each time the sawblade is changed and reset as necessary.
The riving knife tip must never be set lower than the height
of the base of the topmost sawtooth. A setting to rnax. 2 rnrn
under the topmost sawtooth tip is ideal.
The riving knife is an irnportant safety device, which guides the
workpiece and prevents the cut pinching and the workpiece
being thrown backwards. Note the riving knife thickness - refer
to the nurnbers starnped on the riving knife. The riving knife
must not be thinner than the sawblade body and not thicker than
its cutting joint width.
Attention! Close the protection cap (5)
Risk of damage!
Suction hose
Fig. "L1"
attach suction hose Ø 50 and affix hose band clip
Suction connection piece
Place the suction connection piece for the dust extractor onto
the back emission tube
Tool holder
Fig. "M"
Place the supplied tools for the Precisa 6.0 within easy reach
in the tool holder.
english 23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

19013 0490219013 0490319013 04904

Table of Contents