Maintenance - The Handy THMC-A Operators Manual & Parts Lists

MAINTENANCE

WARNING
Improper maintenance & storage of the Multicutter may void your warranty.
Keep the Multicutter clean for better and safer performance.
POWER UNIT
The engine of the Multicutter must be switched off, with the Spark Plug cap removed, before the
machine is unassembled, cleaned, serviced or maintained.
AIR FILTER
Accumulated dust in the air filter will reduce engine efficiency, increase fuel consumption and allow
abrasive particles to pass in the engine. Remove & clean the air filter regularly to ensure optimum
performance.

Remove the air filter cover, by releasing the securing winged screw from the front of the cover.

Lift off the cover.

Remove the sponge air filter from the housing.

Tap the filter to remove light surface dust.

Heavy deposits should be washed out of the Air Filter in soapy water. Allow the filter to dry
completely
.
FUEL FILTER
Check the fuel filter periodically, but be careful not to allow dust to enter the fuel tank.

The fuel tank is fitted with a filter, which is situated at the free end of the fuel pipe and can be
extracted by using a piece of hooked wire.

If the filter is dirty on inspection, replace it immediately with an approved replacement part.

If the inside of the fuel tank is dirty, rinse out with petrol.
SPARK PLUG
Check the Spark Plug after every 10-15 hours of use.

Remove the Spark Plug cap

Using the Spark Plug Spanner supplied, remove the Spark Plug by turning it anti-clockwise.

Clean & adjust the electrode gap to 0.6-0.7mm

If the Spark Plug is visibly damaged or worn, replace immediately (See Specification for details)

Install the new/cleaned Spark Plug to finger tightness, before fully tightening with the spanner.

Replace the spark plug with a similar make & model, every 100 hours or once a year (whichever
comes first)
SERVICING
We recommend your Multicutter power unit is serviced after 15 hours of use & thereafter, every 2
years.
Air Filter Cover Screw
Sponge Air Filter