Installation - Hama EWS-180 Operating Instructions Manual

Warning – Batteries
• Immediately remove and dispose of dead batteries from
the product.
• Only use batteries (or rechargeable batteries) that match
the specified type.
• Do not mix old and new batteries or batteries of a different
type or make.
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do
so could result in the batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and
keep them away from uncoated metal objects.
4. Getting Started
4.1 Inserting the batteries
Measuring station
• Open the battery compartment (22) and remove the contact
breaker. Replace the battery compartment cover.
Base station
• Open the battery compartment (18) and remove the contact
breaker. Replace the battery compartment cover.
4.2 Replacing the batteries
Measuring station
• Open the battery compartment (22), remove and properly
dispose of the dead batteries and insert two new AA batteries
with the correct polarity. Replace the battery compartment cover.
Base station
• Open the battery compartment (18), remove and properly
dispose of the dead batteries and insert two new AAA batteries
with the correct polarity. Replace the battery compartment cover.
Note
Before use, ensure you insert the batteries in the measuring
station first and then in the base station.

5. Installation

Note – Installation
• We recommend initially placing the base and measuring
stations in the intended locations without installing them
and making all the settings described in 6. Operation
– to do.
• Only install the stations once the appropriate settings have
been made and a stable wireless connection is established.
Note
• The wireless transmission range between the measuring and
base stations is up to 30 m in open spaces.
• Before installation, ensure that wireless transmission will
not be disrupted by interference or obstacles like buildings,
trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is sufficient
reception between the intended installation locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during installation. This could damage
the product.
• Before installation, ensure that the chosen wall is suitable
for the weight to be mounted, and make sure that there
are no electrical wires, water, gas or other lines at the
installation site on the wall.
5.1. Base station
• Use the base (19) to position the base station on a level surface.
• Alternatively, you can install the base station on a wall using the
opening (17) on the back.
5.2. Measuring station
• You can also position the measuring station on a level outdoor
surface using the base (19).
• We recommend installing the measuring station securely on an
outdoor wall.
• Install an anchor, screw, nail, etc. in the wall of your choice.
3