Before Machine Start-Up - Nilfisk-Advance BA 551 User Manual
Hide thumbs
Also See for BA 551:
- Operator's manual (32 pages) ,
- User manual (124 pages) ,
- Instructions for use manual (124 pages)
Table of Contents
Advertisement
Available languages
Available languages
USER MANUAL
BEFORE MACHINE START-UP
Deck installation/removal
The machine can be equipped with either the brush/pad-holder deck (18a and 18b) or the cylindrical brush deck (18c).
For deck installation/removal see the procedure in the Maintenance chapter.
NOTE
When the deck is installed/removed, it could be necessary to replace the squeegee, because they must have
the same width. For correct matching of deck and squeegee, see the Squeegee Installation paragraph.
Brush/pad-holder installation/removal
1.
According to the kind of cleaning to be carried out, the machine can be equipped either with brushes (A, Fig. 2) or
pad-holders (B) with pads (C) together with the appropriate deck.
2.
(Only for BA 551 D, BA 551 CD, BA 611 D): Turn the ignition key (80) to "0" position.
(Only for BA 551): Turn off the machine by pressing the switch (71) and/or (73).
3.
If equipped, turn the speed adjuster (84) to idle by turning it counter-clockwise.
4.
Place the brushes (A) or the pad-holders (B) under the appropriate deck (18a) or (18b).
5.
Lower the deck on the brushes/pad-holders by pressing the pedal (11).
6.
(Only for BA 551 D, BA 551 CD, BA 611 D): Turn the ignition key (80) to "I" position.
7.
Press the brush/pad-holder and vacuum system switch (71).
8.
Slightly press the paddle (83) forward to engage the brushes/pad-holders, then release it. If necessary, repeat the
procedure until the brushes/pad-holders are engaged.
WARNING!
(Only for BA 551 D, BA 551 CD, BA 611 D): Do not press the paddle (83) completely, otherwise the machine
will start moving.
A slight pressure on the paddle (83) is enough to engage the brushes/pad-holders and to turn on the relevant
motors.
9.
To remove the brushes/pad-holders, the deck must be lifted by pressing the pedal (11), then press the switch (75) (if
equipped) and wait for the brush/pad-holder to fall on the floor.
(Only for BA 551 D, BA 551 CD, BA 611 D): Turn the ignition key (80) to "0" position.
(Only for BA 551): Press the switch (71).
If the machine is not equipped with the automatic release system (switch 75), manually remove the brush/pad-holder from
the hub, by turning it in the opposite direction to the normal rotation direction.
18
Figure 2
S311317
909 6752 000(2)2006-10 A
Advertisement
Chapters
Table of Contents
