Power Disconnection Switch; Pre-Riding Inspection - PGO G-MAX Manual

POWER DISCONNECTION SWITCH

The power disconnection switch will be activated to stall the motorcycle within 6 seconds in case of rollover of
a running motorcycle.
It is necessary to disconnect and reconnect the power supply for next start-up with the stalled motorcycle
supported.
Attention:
• Some error messages (Code: P0261) will be indicated on the display panel with the power disconnection
switch activated. These messages are not disadvantageous to the vehicle.
• Bring the tumbled motorcycle to any PGO dealer for further check.

PRE-RIDING INSPECTION

PRE-RIDING INSPECTION
Please do the inspection as following before riding:
Please do the inspection as following before riding:
FRONT BRAKE
REAR BRAKE
THROTTLE GRIP
LUBRICANT
ENGINE COOLANT
TIRE
CONTROLLER
/GAUGE CABLE
BRAKE LEVER(HANDLE) Check if smooth operation. Add lubricant if necessary.
CENTRAL STAND
ASSEMBLY
/FITTING
FUEL TANK
LAMP/SIGNAL LIGHTS
ITEM
Check the brake function, clearance , brake oil level, see if it is leaking.
If necessary, may refill FMVSS DOT 4 OR SAEJ 1703 brake oil.
Check the brake function and clearance, proper adjustment if necessary.
Check if it is smooth, put some lubricant .
Adjustments if necessary.
Check the oil level/according to the request to refill oil.
Check the coolant level, refill it to the upper level if it is below the lower level.
Check the pressure, the wear out situation.
Check if smooth operation. Add lubricant if necessary.
Check if smooth operation. Add lubricant if necessary.
Check all the assembling parts, fixing & adjusting if necessary.
Check the fuel level. Refill up if necessary.
Check if it is operating good condition.
PROCEDURE PAGE
26 46
28 50
26 46
28 50
31 34
29
31
28
30
30
33
─
26
28
─
─
23
24
31
34
25