Table of Contents
Advertisement
Hints and Tips
If a problem does occur, it may often be due to something very minor. The following table
contains various tips.
Menu
No power.
GB
The remote
control does
not function.
Very little or
no sound is
coming from a
DVD.
No picture.
The picture is
not clear.
Loud hum or
noise is heard.
The disc does
not play.
30
•
Ensure the mains plug is connected.
•
Make sure that the unit is turned on.
Make sure that you have selected ON mode.
•
•
Use the remote control near the unit.
•
Point the remote control at the remote sensor on the unit.
•
Replace the battery in the remote control with a new one.
•
Remove any obstacles between the remote control and the unit.
Make sure the unit is not paused. Press the PLAY/PAUSE
•
on the unit or the remote control.
•
Make sure the unit is not in fast-forward or fast-reverse mode.
Press the PLAY/PAUSE
control.
•
Make sure the AUDIO/VIDEO input/output connections are
correct.
•
This unit does not support DTS audio decoding system. Press the
AUDIO/ANGLE button on the remote control to change the audio
setting to 2-Channel Analogue mode.
•
The unit has overheated. Shut it off for 30 minutes to allow it to
cool down.
•
The volume control is too low. Increase the volume.
•
The region number of the disc doesn't match the region number
of this unit.
•
The DVD is dirty. Gently clean the disc.
•
The disc is scratched.
•
The plugs and sockets are dirty. Wipe them with a cloth slightly
moistened with alcohol.
•
Clean the disc.
•
The disc is scratched or the file is corrupt.
•
There is no disc inside the unit ("No Disc" appears on the screen).
•
Insert the disc correctly with the graphics facing up.
•
Clean the disc.
•
A non-valid disc has been inserted, or the disc region number
does not match the region number of the unit.
•
Condensation may have formed inside the unit due to a sudden
change in temperature. Wait about an hour for it to clear and try
again.
Description
button on the unit or the remote
button
Advertisement
Table of Contents
